www.petsafe.net 11
10 www.petsafe.net
EN
ES
FR
IT
NL
DE
.
4. Remove the Filter Housing from the Pump by
lifting straight up (
Fig. 11
).
5. Open the Filter Housing and remove the
Charcoal Filter from inside. Set the Filter
Housing aside for cleaning.
6. Remove the Rubber Cap affixed to the raised
post by inserting a finger under the lip and
pull straight up to remove (
Fig. 12
).
7. While securely holding the electrical power
cord and the bottom of the Bowl with both
hands, pour out the remaining water inside
the Bowl into a sink.
8. With the In-Line Plug disconnected and water
removed, grab the Pump and lift straight
up to disengage the suction cups. Continue
pulling the Pump’s electrical power cord
up and out through the raised post in the centre of the Bowl. Once the Pump is
completely removed from the Bowl, separate the Foam Filter and set aside for
proper cleaning.
9. Once the Pet Fountain is completely disassembled, you will have: the Bowl and
Tower, two rubber pieces, the Filter Housing, a Charcoal Filter, Foam Filter and
the Pump.
10. Rinse the filters with water only, or replace them.
11. See the Pump Maintenance section of this Operating Guide for detailed
instructions on how to properly clean your Pump. DO NOT PLACE
PUMP IN DISHWASHER!
12. Handwash the Pet Fountain parts with warm water and soap. You can also put the
Pet Fountain in the top rack of the dishwasher. If possible, it is recommended that
you turn down the heat of the water inside the dishwasher.
13. If you have trouble reaching certain spots or hard-to-reach corners, try using
a cotton swab or purchase the Drinkwell
®
Cleaning Kit, a 3-Piece Brush kit. To
purchase a Cleaning Kit, visit our website at www.petsafe.net to locate a retailer
near you or contact the Customer Care Centre.
Fig. 11
Fig. 12