Petsafe Drinkwell D2KA-RE, Руководство по эксплуатации

Страница: 8 / 32

www.petsafe.net 9 8 www.petsafe.net
EN
KO
7. Remove the Reservoir by lifting up and away from the Pet Fountain. Turn the
Reservoir upside down and remove the Reservoir Cap. Fill the Reservoir with
water and replace the Reservoir Cap. Holding the Reservoir upside down and
backwards to the Pet Fountain (
fig. 4
), quickly turn the Reservoir right side up
and slide into place (
fig. 5
). The water level will equalize to approximately 1.27
cm below the rim of the Bowl.
8. Place Pet Fountain in desired location. If placing on carpet, tile or wood flooring
use a protective surface such as a towel or placemat to protect your floor from
splashing or dripping from your pet.
9. Before you plug in the Pet Fountain make sure the Power Cord and your hands
are dry. Plug the Pet Fountain into a standard electrical outlet.
10. Set your desired flow rate with the Flow Control Knob,
located to the right of the Receiving Ramp. In the 10
o’clock position for a smaller stream or in the 2 o’clock
position for a stronger stream (
fig. 6
).
11. Add water as needed. Do not let the water level fall
lower than the Flow Control Knob or you may burn
out the Pump. Do not pick up a full Pet Fountain by the
Housing. Only use the handles located on the bottom of
the Bowl on either side of the Pet Fountain.
pet fountain Disassembly & Cleaning
Important:
Pet Fountain must be cleaned to continue working normally.
CHARCOAL fILtERS: Change every 2 to 4 weeks.
1. Charcoal Filters should be changed every two to four weeks. Replace Charcoal
Filters more frequently when using the Pet Fountain for multiple pets or pets that
produce a lot of saliva.
2. Charcoal Filters are an added feature of the Pet Fountain. Their use is not required
for normal operation.
3. Charcoal Filters may be rinsed out when the Pet Fountain is cleaned. Do not wash
with soapy water since you cannot remove all the soap residue.
fig. 4 fig. 5
mIn mAX
fig. 6