petsafe.com
5
9. Hold the reservoir over the reservoir base. Quickly turn it upside down
and place the spout of the reservoir cap into the reservoir base (
Fig. 3
).
10. Set your desired flow rate with the flow control knob, which is next to the
ramp inside the bowl. When the flow control knob is in the 10 o’clock
position, flow is at its lowest. When the flow control knob is in the 2
o’clock position, flow is at its highest (
Fig. 4
).
11. Make sure the electrical power cord, the power adaptor and your hands
are dry. Plug the pet fountain into a standard electrical outlet.
12. Add water to the bowl as needed. Do not let the water level fall below
the flow control knob or you may risk pump failure.
Pet Fountain Disassembly & Cleaning
CARBON FILTER:
Change every 2 to 4 weeks. Replace the carbon filter
more frequently when using the pet fountain for multiple pets or pets that
produce a lot of saliva.
1. Lift the reservoir out of the back of the pet fountain and quickly
turn upright.
2. Unscrew the reservoir cap and remove the black o-ring.
3. Next, unplug the pet fountain and remove the housing lid.
4. Remove the carbon filter and dispose.
5. Empty the water out of the pet fountain.
6. Remove the housing by pressing in the tabs at the sides and lifting up
(
Fig. 5
).
7. The flow control knob is not attached and it will separate when the
housing is removed.
8. The flow control knob and intake plate are not attached and are freed
when the housing is removed.
9. Turn the bowl over and unlock the pump from its cavity by slipping your
finger into the indentation behind the pump and pulling that end of the
pump out toward you, so that it has turned a quarter of a turn (
Fig. 6
). Do
not attempt to remove the pump without turning it 90 degrees; this may
damage the pet fountain and cause a leak.
10. Now that the pump is unlocked, remove it from the pet fountain. If you find
this difficult, you can push the pump out from the bowl side.
11. Clean the plastic parts with warm water and soap. You can also put
the pet fountain in the dishwasher. Remove the pump before placing
in the dishwasher. NEVER PLACE THE PUMP OR RESERVOIR IN THE
DISHWASHER! If possible, it is recommended that you turn down the
heat of the water inside the dishwasher. The pet fountain may also
be cleaned with a diluted vinegar solution (20% white vinegar and
80% water).
Fig. 3
Fig. 4
Flow Control
Knob
Fig. 5
Fig. 6
