19
petsafe.com
Follow all safety instructions for your power tools. Be sure to always wear your
safety goggles.
Cross Hard Surfaces
(driveways, sidewalks, etc.)
•
Concrete Driveway or Sidewalk (8C):
Place the boundary wire in a convenient
expansion joint or create a groove using a
circular saw and masonry blade. Place the
boundary wire in the groove and cover with
an appropriate waterproofing compound.
For best results, brush away dirt or other
debris before patching.
•
Gravel or Dirt Driveway (8D):
Place the boundary wire in a PVC pipe or
water hose to protect the boundary wire
before burying.
Step 9: Place the Boundary Flags
The boundary flags are visual reminders for your pet of
where the warning zone is located.
1. Place the test light contacts on the contact points. Hold
the receiver collar at the height of your pet’s neck (
9A
).
2. Walk towards the warning zone until the receiver
collar beeps (
9B
).
3. Place the boundary flag in the ground along the
boundary wire (
9C
).
4. Walk back into the pet area until the beeping stops.
5. Repeat this process along the warning zone until it is
marked with boundary flags every 10 ft. (
9D
).
Note:
If you cannot hear the beep, refer to the test light
instructions in Step 7. To prevent an unintended correction,
after the boundary flags have been placed, be sure to set
the static correction on the receiver collar back to level 1,
which is tone only.
8C
8D
10 ft.
Boundary
Wire
Boundary
Wire
9A
9B
9C
9D
