Petol Hydra-Tork U8184, Руководство по эксплуатации

Страница: 9 / 29

9
Overloading / Shock Loads / Side Loading
Do not attempt to “inch loads which are beyond the rated capacity of the tool.
Do not Strike the tool with a hammer or other object while force is being exerted in an attempt
to loosen a “frozen” joint.
Side pull can be caused by pulling or pushing on the tong in a direction that is not along a
perpendicular plane, unleveled mounting of the tong or vise, inadequate support of the part
being broken out, and improper seating of the part being broken out in the tong or vise.
Improper seating will occur when the diameter of the part is not consistent within the width of
the tong or vise jaw.
Environmental Conditions
Wrench chains operate in widely varying environments, from wet outdoor conditions to mildly
or highly corrosive industrial atmospheres. They can also be exposed to abrasives such as sand
or grit.
The possible effects include:
Moisture - Corrosion and rust reduce chain strength by causing pitting and cracking.
Temperature - Very cold temperatures reduce chain strength by embrittlement.
Chemical Solutions or Vapors - Corrosive attack of the chain components’ grain structure
and/or the mechanical connections between the chain components (crevice corrosion)
may occur. Cracking often is microscopic. Propagation to complete failure can be
eventual or sudden.
Abrasives - Accelerated wearing and scoring of the articulating chain members (pins and
plates) may occur, with a corresponding reduction in chain strength. Due to
inaccessibility of the bearing surfaces (pin surfaces and plate apertures), wear and scoring
are not readily noticeable.
These conditions, when coupled with normal chain wear and inherent residual stress
(normally in the chain as constructed); can result in environmentally assisted failure. It is
impossible to predict chain life under complex conditions, as the degree of hostility and
its effects are dependent on many variables such as temperature, time of exposure,
concentration of corrosive atmosphere or medium, degree of abrasive wear, etc.
Establishing the degree and frequency of unpredictable dynamic loading is also difficult.