8
Operating Guide
Step
1
Prepare the Remote Transmitter:
How to use the Remote Transmitter
Battery installation
To install the battery, open the battery
cover at the back of the transmitter.
Install the battery (1 X 6F22 9V)
ensure the polarity is correct.
The transmitter will TURN ON
automatically.
1.
transmitter
，
it will on automatically
.
To install the battery , open the battery cover at the back of the
2. Select the right channel to match the different dogs by Knob switch
at the right upside. there are 3 channels to train up to 3 dogs.
3. Press M1 button to select the memory group(A).
4. Set to the different modes by pressing the Mode Button-The LCD
images will change from(B).
5. Press Up/Down buttons on right side to set Beep Sound, Vibration
and Static Shock level(C).
6. Press M2 button to save the setting to the memory and There are 3
memory groups for each channel (B).
7. Press Launch Y button to send the signal and train the dog.
8. The transmitter will go into STANDBY MODE if not operating for
2 minutes (the LCD screen is off) and will TURN OFF if not operating
for 5 minutes.
9. In STANDBY MODE, press any button to wake it up. When turn off
status, hold the Mode button for 5 secconds for TURN ON.
Notes: These three modes could be combined freely and work at same
time, so please set those modes you don't want at the level 0 .
A
C
B
' ' ' '
Step
2
Prepare the
Receiver :
Collar
Charge the
Receiver
Collar
1. To TURN ON the
Receiver, press the on/off button, after a
beep, the green LED will be on and flashing every 4 seconds and
it is in working mode.
Collar
2. Open the rubber cover and Connect the charger connector to the
charging hole.
3. Plug the charger into a standard outlet .
4. The red LED will be on (A).
5. Charge the
Receiver at least 6 hours for the first charge.
Collar
6. After fully charged, the red LED light will be turned to green LED
light automatically (B).
7. Put back the rubber cover to keep charging hole clean.
8. If the battery is needed to recharge, the
receiver will beep
for 20 seconds.
collar
NOTE
: Please check whether the battery needs to recharge before you
use it. When you turn the receiver on, if there are beeps for 20 seconds,
you need to recharge it before using.
A
B
9
Step
3
Encode between Remote Transmitter and
Receiver :
Collar
1.
transmitter , it will on automatically
.
To install the battery , open the battery cover at the back of the
