7
4.
First run
During the first run of Perun V3, trigger and selector sensors have to be calibrated. After the
battery is plugged in for the first time, Perun V3 will automatically enter
calibration mode
.
Take following steps:
1) Plug the battery in.
2) Set the selector in „AUTO” position (or “SEMI” in AK type replicas).
3) Pull the trigger and hold it in any position, in which a continuous sound signal can be heard,
until the signal stops. If you want a short trigger, stop pulling the trigger further once the signal
starts to be heard and keep it there until the setting is saved. In other case pull the trigger
further and hold. Perun V3 will now remember this trigger position and start to fire once it has
been reached.
4) Set the selector in „SEMI” position (or “AUTO” in AK type replicas).
5) Repeat the trigger procedure from step 3).
If the procedure has passed without problems, the next time battery is plugged in Perun V3
will not enter into calibration mode and will be ready to shoot. However, if after finishing step
5), you will hear a long, single signal meaning that there are problems with “SEMI” and “AUTO”
position detection, the next time the battery is plugged in, Perun V3 will enter calibration
mode again. At this point repositioning of selector sticker may be needed.
In case there is a need to go through the calibration procedure again, enter the programming
mode on any selector position, press the trigger 12 times and save the setting by holding the
trigger until a sound signal can be heard.
5.
Fuse
40A fuse can be installed on the wiring. If the replica has spring softer than M130
and
the rate
of fire is lower than 25RPS, it is recommended to change the fuse to 25A (included). After
doing so, test if the fuse parameters are not too low by firing a couple of quick shots in semi-
auto mode.
6.
Factory settings
Perun V3 is delivered with functions programmed following way:
- single fire on „SEMI” selector position (automatic fire in AK type replicas),
- automatic fire on „AUTO” selector position (single fire in AK type replicas);
- AB off,
- precocking off,
- precocking power set to 1 (this will only have effect, if precocking is enabled),
- Li-Po protection off,
- double shot off.
To comply with the original, in AK type replicas firing modes should reprogrammed after first
run, because „SEMI” and „AUTO” selector positions will be switched between each other.
