YH414561/YH414562/YH414563/YH414564 Learning Universal Remote Control
5
Remark:
1. If you want exit the learning mode, Press and release LEARN key.
2. In learning mode you must not be more than 30 mm between 2 remotes., and the 2
remotes must be put in a straight line.
3. It will exit the learning mode if you don’t press any keys in 30 seconds .
4. You can press SET and 4 together to delete all buttons you have learnt under the device
button, the LED will flash 2 times to confirm it.(First choose the device button which
you like to delete)
6. The last learnt singal will overwrite the previous signal.
7. About 14 commands can be stored in this remote control .The last learnt signal will
overwaite previous signal stored in that device and button.
Other Functions
A. Display the Device Code:
The device code, which has been set up in your new remote control, can be called up
as follows:
1.Press the SET key and hold it down, now actuate number key “1” to display the
100th position of the 3-digit code. Count the numbers the LED flashes. If the
LED doesn’t flash, that means the digit is ZERO.
2.Similarly, press the SET key and hold it down, at the same time actuate number key
“2” to display the 10
th
position of the 3-digit code.
3. Press the SET key and hold it down, at the same time actuate number key “3” to
display the 1
st
position of 3-digit code.
Example for Code 028:
a. Press SET and “1”, LED flashes 0 time, no flashes.
b. Press SET and “2”, LED flashes 2 times.
c. Press SET and “3”, LED flashes 8 times.
B. Reset / Delete Function:
To delete the codes which have been set up in the remote control, press and hold down
the SET key, then press the “0”key simultaneously for more than 3 seconds and then
release the both pressed keys. The LED will flash twice and all the set up data and all
learn commands in the remote control are deleted.
Remark: Please don’t operate this function if you don’t want to delete all the settings.
C.
Write-protection of Device Codes:
To protect the device codes from being inadvertently overwritten / deleted, you can
carry out the following:
1. Press the device key (e.g. Projector) that you would like to protect on your remote
control.
2. Press and hold down the SET key and press the “7” key at the same time. Then
release the both pressed keys, the LED will flash twice and the code is then
protected from being overwritten/deleted.
Remark: To cancel write protection, press the SET key and hold it down, and activate the
“8” key at the same time, and then release the both pressed keys. The LED
flashes twice and the protection have been cancelled.
