6
CLEANING & MAINTENANCE
Press & hold
Clean Cycle
button for 3 seconds
LED light turns off when cycle is complete
Unplug unit and release drain hose from clip on side of
unit. Unplug drain hose from holder and empty water
into a sink, or bucket placed lower than the ice maker.
Drain the hose and reattach hose to clip holder and clip
hose to the side of the unit using the magnetic holder.
Plug the unit in and repeat Step 2 with clean, fresh water
3-4 times with draining in between each cycle. Always
unplug the unit before and during the draining process.
Fill water resevoir
with 5 cups of water
+ 1 teaspoon of
bleach to run a
Cleaning Cycle
CUPS
Teaspoon
Bleach
Water
5
1
2
Step
TIP:
Cleaning is recommended 1X per week if using ice maker daily,
or in between uses. Some noises are common during ice making and
cleaning cycles.
FIRST USE
3
Step
4
Step
5
Step
1
Step
OPERATING INSTRUCTIONS
Making Ice
After cleaning and flushing for initial use, locate the appliance on a
stable counter top or flat surface with a minimum of 4” of space all
around the unit, including the back of the unit for proper ventilation.
Remove the water reservoir plug and use the water funnel to fill
with potable water. Keep water to the Max Fill line on the water
level indicator. DO NOT OVERFILL. DO NOT use any liquid except
water as it will nullify the warranty. Due to water hardness in some
areas, it is recommended to use Distilled or Purified Water.
Press the POWER button to turn on the appliance.
Press the SOFT ICE button to start making ice. Ice will be
produced within 10 minutes and continue until the bin is full
or the reservoir requires more water.
Ice will be made continuously from the recirculation of melted ice
water, but
it is recommended to power off the appliance and
drain the reservoir when not in use, or relocating it.
• Use potable water only.
• Use PURIFIED WATER to improve ice making performance.
• Water TDS level must be 5~100 mg/L (PPM).
• Water hardness must be no greater than
50mg/L (3 grains/gal).
2
Step
3
Step
4
Step
5
Step
1
Step
NOTE:
NOTE:
UV sanitizing light illuminates ice bin when unit is in
Cleaning Cycle, making ice, or in power standby mode.
Power off unit when not in use.