7
•
One key fob tags with unique serial numbers.
o
Attach the key fob tagto the driver’s keychain.
•
A 3 foot RFID antenna extension cable.
o
Use cable in case RFID antenna cable is too short in the installation.
Mount the RFID antenna near the vehicle’s ignition switch within 6-8 cm of where the key fob
will be located when hanging down from the keychain. Plug the RCA Male connector to the
RFID device. Use the RCA extension cable if the antenna cable length is insufficient to
connect to the RCA Female connector on the device.
Figure 9: Mounting the RFID antenna near the vehicle ignition switch
Figure 10: Connecting the RCA extension cable and connecting the RCA-M to the device
Once the cable is connected, the operation of the RFID antenna interface and functionality
can be validated as follows:
•
Check to see if the RFID Yellow LED light comes on and remains solidly lit.
•
If the LED remains lit, the RFID circuit is operational.
•
If the LED is off, check the connections to ensure that the cable is properly seated on
the RCA connector on the OttoView device.
o
If the connector is properly seated and the RFID light is still off, contact
PERSENTECH by email at:
for customer support.
With the RFID antenna mounted and installed, place a keychain with the attached key fob
into the ignition.
