Perrot ZN23-3D, Инструкция по эксплуатации и обслуживанию

Страница: 11 / 20

TDP002d ‐ e ‐ f.doc Rev. 26.11.2015 Seite ‐ Page ‐ Page 11 / 20
Perrot REGNERBAU CALW GmbH Industriestraße 19 ‐ 29 / D ‐ 75382 Althengstett / Germany
Telefon : 0049 ‐ 7051 ‐ 162 ‐ 0 / Fax : 0049 ‐ 7051 ‐ 162–133
E ‐ mail: perrot@perrot.de / E ‐ mail Konstruktion : technik@perrot.de
c.) Setting the part circle angle
Infinitely variable by pulling (not pressing) the relevant end of the upper or lower spring stop.
6. Maintenance
6.1 Lubrication
Lubrication points
The lubrication points at the impact lever should be lubricated with little quantities of grease.
The lubrication point at the bearing should be lubricated once a year. The grease may be pressed in
only at a very low pressure, in order not to damage the cover of the ball bearing.
6.2 Fitting a spring bearing with torsion spring
a)
Set torsion spring bearing acc. to sketch with an angle of 45 degree.
String stop
Pull the spring stop here
String stop
Bearing
Impact lever
Torsion spring
Spring bearing