Permobil Koala, Руководство по обслуживанию

Страница: 22 / 32

22
Control panel
Fig. 48. The Control panel and
Seat control panel bracket.
Fig. 51. The Seat control panel
electrical connector.
Fig. 49 The Control panel and
Seat control panel fixings.
Fig. 50. Removing the Seat control panel lid.
Control panel
Removal
1. Switch off the main power switch on the control
panel.
2. Put the circuit breaker in the “OFF” position,
see page 23, fig. 52.
3. Disconnect the control panel cable by pulling the
connector at the rear of the control panel straight
backwards.
4. To remove the control panel, remove the screws
holding the common bracket for the control panel
and Seat control panel, see fig. 48. Remove the
control panel bracket by removing the two screws
on the rear of the control panel, see fig. 49.
Fitting
Fitting is the reverse procedure.
Seat control panel
Removal
1. Switch off the main power switch on the control
panel.
2. Put the circuit breaker in the “OFF” position,
see page 23, fig. 52.
3. Remove the cover of the Seat control panel by
pulling it straight upwards. If the lid is stuck,
you can carefully use a screwdriver to pry
between the lid and the lower part of the end of the
box, see fig. 50.
4. You can now lift the circuit board and cable out
of the box.
5. Disconnect the cable from the circuit board by
pulling the connector straight upwards,
see fig. 51.
6. To remove the control panel, remove the screws
holding the common bracket for the control panel and
Seat control panel, see fig. 48. Remove the Seat
control panel bracket by removing the two screws on
the underside of the box, see fig. 49. Note the
position of the bracket for refitting.
Fitting
Fitting is the reverse procedure.