Permobil C500, Руководство по обслуживанию

Страница: 56 / 68

56
Trouble Shooting guide
Troubleshooting R-net
3.16 DIME Error
This occurs when the control system detects an ID conflict between two modules in the system.
If a new module has been added:
• Disconnect the new module and cycle the voltage.
• If no error occurs, connect the new module to the system and cycle the voltage.
• If the error recurs, the new module must be the cause of the problem.
If no new modules have been added:
• Disconnect one module at a time and cycle the voltage.
If the error persists after the checks listed above have been performed, consult your service contact or
Permobil .
3.17 Memory Error
This is a non-specific memory error that may be caused by any of the system modules.
• Check all cables and connections.
• Cycle the voltage.
If the error persists and the system includes third-party modules:
• Disconnect all modules that do not come from PGDT and cycle the voltage.
If this has dealt with the error:
• Connect one third-party module at a time and cycle the voltage each time.
• If the error recurs after one of the voltage cycles, the last module to be connected must be defective.
If the error persists after the checks listed above, the power module may be defective. Read more in
section 5.
3.18 PM Memory Error
This is a specific error in the power module.
• Check all cables and connections.
• Reprogram the control system with the help of R-net’s PC programmers.
This should be done with either the latest specific program file for the wheelchair or Permobil’s original
program file.
If the error persists after the checks listed above, the power unit may be defective. Read more in section
5.
m
NB
Programming should only be performed by persons with sound knowledge of control systems from PGDT. Incorrect programming
can mean that the wheelchair is not safe to use. Permobil cannot be held responsible for losses of any kind if the control system
factory settings are altered by programming.