Permobil C500, Руководство по обслуживанию

Страница: 25 / 68

25
Magnetic wheel lock
Remove the wheel lock release cable.
Remove the magnetic wheel lock.
Magnetic wheel lock
Removal
1. Raise the seat to the highest position. If
the chassis is equiped with fixed seat post,
see page 38. If the seat lift does not work
normally because the batteries are discharged
or the actuator is defective, the seat can be
raised/lowered manually, see page 30.
2. Switch off the main power switch on the control
panel.
3. Put the circuit breaker in the “OFF” position. It is
accessed through a hole in the chassis cover;
see page 45.
4. Remove the seat lift cover, chassis cover and
the front fender on the side in question, see
page 7.
5. Disconnect the electrical connection of the
magnetic wheel lock. The connections are
positioned on the inside of the chassis, on
each side of the seat lift/seat post.
6. Pull the cable casing forward, out through the
slot in the cable holder and detach the wheel
lock release cable from the magnetic wheel
lock; see fig.
7. Lift up and chock up the wheelchair chassis
so that the wheel in question is free of the
ground.
8. Loosen the shock absorbers front end. Follow
the instructions on page 18 until paragraph 4.
9. Position the slewing bracket more downwards
for easier access to the magnetic wheel lock,
see fig.
10. Remove the three screws that secure the
wheel lock; see figure 38. Note the position of
the wheel lock release lever and rubber seal’s
placement to facilitate subsequent reassembly
Remove the wheel lock with wheel lock disk
and cover.
The electrical connections of the magnetic wheel
locks are positioned on the inside of the chassis,
on each side of the seat lift/seat post.
Electrical connection of the magnetic wheel locks.