7
Operation & Installation Manual
Signature Series (HP24 and HP48 models)
PREPARING THE SPACE
Make sure that the space that the opening where the Perlick
cabinet(s) is/are to be installed is properly prepared. Refer to
Figures 1 and 2 (page 5) and Figures 3 and 4 (page 6) to ensure
proper space dimensions and electrical service are correct for the
model to be installed.
CAUTION
If cabinet is being installed under a countertop it is recommended
that the countertop be supported by structure other than the
refrigerated cabinet to prevent damage to the counter top.
IMPORTANT NOTE:
For a cabinet door to operate properly, the
door must open a minimum of 90°. Use a minimum 3-inch filler
in corner installations to assure a 90° door opening. Allow 24”
clearance in front of the unit for full door swing, shelf pull-out or
drawer pull-out.
IMPORTANT NOTE:
Make sure the floor under the unit is level
with the surrounding finished floor. Protect a finished floor with
plywood, cardboard or some other suitable material before moving
the unit into place. Failure to do this may result in damage to the
floor.
PREPARING ELECTRICAL CONNECTIONS
A 115 volt, 60Hz, 15 amp circuit breaker and electrical supply are
required. A separate circuit is required for each Perlick unit installed.
Follow the National Electrical Code and local codes and ordinances
when installing the receptacle.
All Perlick units come equipped with a NEMA 5-15P 90° plug with
a minimum of 5-feet of cord extending beyond the rear of the
cabinet. The electrical outlet must be flush with or recessed into
the back wall.
IMPORTANT NOTE:
Never use an extension cord to extend the
power cord to the electrical receptacle.
DANGER
ELECTROCUTION HAZARD
Electrical grounding is required. This appliance is equipped with
a three prong (grounding) polarized plug for your protection
against possible shock hazards.
•
Never remove the round grounding prong from the plug.
•
Never use a two-prong grounding adapter.
•
Never use extension cords to connect power to the unit.
Where a two-prong wall receptacle is encountered or a longer
power cord is required, contact a qualified electrician to have it
replaced in accordance with applicable electrical cords.
DANGER
Failure to comply with the above electrical guidelines may result
in possible injury, death, fire or loss of property.
UNPACKING AND MOVING
CAUTION
Do not cut cardboard sleeve covering the unit. Cutting may
result in damage to the exterior of the cabinet.
1. Uncrate the unit outside on a flat surface. Remove the card-
board sleeve by removing the banding holding the sleeve to
the shipping base. Carefully lift the cardboard sleeve up over
the top of the unit.
2. Carefully lift unit off base and onto a hand truck or dolly (this
should be done with a minimum of two people; larger units
may require additional helpers!). Make sure the unit is bal-
anced on transporting device using soft, flexible strapping.
Protect unit surfaces with cloth material where strapping
contacts unit.
3. Before moving unit, secure door to unit with tape to the door
closed.
4. Carefully move unit to installation site and place in front of
opening.
WARNING
A minimum of two people should lift the cabinet off the base to
prevent possible personal injury.
Содержание HP24BS
Страница 2: ......
