UltraPort Serial Adaptors User Guide
Installing under SCO UnixWare
Page 73
Chapter 2 Installing drivers and host cards
etc/setultrap -f /dev/term/z1 -m 485hdx -t term -b 5 -sets serial port z1 to EIA-485 half duplex,
termination enabled, control bit-delay 5.
These commands may be added to a startup script to cause them to run automatically
whenever the system is started. A sample commented out startup script (/etc/rc.setulrap) is
supplied with this driver.
Removing drivers and utilities from your system
To remove the software drivers from your system under the SCO UnixWare operating system
proceed as follows:
1. At the command prompt, type
pkgrm spd
and press
Enter
The SPEED driver and associated utilities are now removed from your system.
