Perle PoE/PoE+ 10/100/1000 Ethernet Media Converter
Installation Guide
18
1.
Feed the power cord through the opening in the power cord relief clip.
2.
Attach the power cord relief clip to the chassis and secure with the provided
screw.
3.
Plug the power cord into the AC power connector at the rear of the chassis.
4.
Plug the other end of the power cord into an appropriate power outlet.
Powering up the Perle Media
Converter
1.
Connect the Perle supplied power adapter to the media converter.
2.
Connect the power adapter to a power source.
3.
Check that the PWR LED light is lit.
Extended Temperature models supplied with a Pluggable
Terminal Block
1.
Unplug the terminal block from the Media Converter.
2.
Ensure the Power Source is off.
3.
Strip both wires 5mm (3/16th inch)
4.
Loosen the terminal block screws and connect Positive (+) wire to the left
terminal. Connect the Negative (-) wire to the right terminal. Tighten
Terminal screws (0.22Nm-0.25Nm torque).
5.
Plug the terminal block into the Media Converter
6.
Turn on power source.
7.
Check that the PWR LED light is lit.
8.
For extra power cable strain relief, attach the strain clip to the case as
shown below, and thread the power cable through the clip in either one
or two loops.
