Perkins 103-06, Руководство по ремонту

Страница: 6 / 80

v
Safety Precautions
THESE SAFETY PRECAUTIONS ARE MOST IMPORTANT Reference must also be made to the local
regulations in the country of operation.
Do not use these engines in marine applications (Except Perama versions).
Do not change the specification of the engine.
Do not smoke when you put fuel in the tank.
Clean away any fuel which has spilled and move material which has fuel contamination to a safe place.
Do not put fuel in the tank during engine operation (unless absolutely necessary).
Never clean, lubricate or adjust the engine during operation (unless you have had the correct training when
extreme caution must be used to prevent injury).
Do not make any adjustments you do not understand.
Ensure the engine is not in a position to cause a concentration of toxic emissions. Persons
in the area must be kept clear during engine and equipment or vehicle operation. Do not
permit loose clothing or long hair near parts which move.
Keep away from parts which turn during operation. Note that fans cannot be seen clearly while the engine is
running.
Do not run the engine with any safety guards removed.
Do not remove the radiator cap while the engine is hot and the coolant is under pressure as dangerous hot
coolant can be discharged.
Do not use salt water in the fresh water cooling system or any other coolant which can cause corrosion.
Keep sparks or fire away from batteries (especially while during charge) or combustion can occur. The battery
fluid can burn and is also dangerous to the skin and especially the eyes.
Disconnect the battery terminals before you make a repair to the electrical system.
Only one person must be in control of the engine.
Ensure the engine is only operated from the control panel or operators position.
If your skin comes into contact with high pressure fuel, get medical assistance immediately.
Diesel fuel and used engine oils can cause skin damage to some persons. Use protection on the hands (gloves
or special skin protection solutions).
Do not move equipment unless the brakes are in good condition.
Ensure that the transmission drive control is in "Neutral" position before the engine is started.
Fit only genuine Perkins Parts.
Do not use ether to start these engines.