Perkins 103-06, Руководство по ремонту

Страница: 52 / 80

E. Engine starts.
F After the engine starts, return switch to run
mode.
G. The magnetic switch loses attracting force, the
pinion returns by the return spring with the shift
lever and disengaged, and the motor stops.
B. Remove the dust cover and take out the E ring
and thrust washer, where fitted. Remove the
rear cover and brush holder.
-
Ii
PB108
C. Remove the bush assembly and yoke.
Connecting diagram. -
Handling Method
A. Fix the gear case firmly to the engine side so that it
is not affected by the large impact when the
motor starts.
Standard gap between the pinion and ring gear
is 3-5mm.
Use a wire of specified thickness and tighten it
firmly. Insufficient tightening causes larger
contact resistance and makes starting difficult.
B. Precautions for starting
a. Ensure battery is charging. Insufficient
charging will make starting more difficult.
b. After the engine has started, turn switch to
run mode.
c. When it is difficult to start the engine by the
starting switch, turning it frequently will
decrease the battery electricity. In such a
case, turn off the switch once and then keep
it on for about 10 seconds. Repeat this proce-
dure several times.
D. Remove the shift lever and armature.
PB109
PB110
d. Never turn on the starting switch while the
engine is operating.
- Disassembly and Reassembly (Typical)
E. Remove the pinion, as shown by first removing
the snap ring ref PB111. Re-assembly by using
puller as shown in PB112.
A. Remove the solenoid (magnetic switch).