Pergola kits USA PREMIUM VINYL PAVILION, Инструкция по сборке

Страница: 13 / 36

Locate the corner braces.
Take the 2x4 board out from
center of brace.
Moving to the short side,
hold fascia in place, butting
the top of the fascia board
against a square following
the pitch of the decking.
Fascia should not be lower
than the pitch of the roof
decking; the end of the fascia
should extend out to be flush
with the long side fascia
board.
Keep the brace flush on the
outside of the post. Fasten to
post with two 3 1/2” screws
and up into the header with
two 3 1/2” screws. Line the
top of the brace up with the
header seam above staying
5/8” from flush. Being sure to
keep the back of the brace
flush with the post below.
Next, drive 2 1/2” screws
every 16” along the entire
length of the fascia board.
Follow these same steps with
the other short-sided fascia
board.
13
41
42
40
43