Performax 241-0991, Руководство оператора

Страница: 10 / 20

Page 9
OPERATION
REMOVING THE SAW BLADE
(FIG.2)
1. Unplug the reciprocating saw from the
power supply.
2. To remove the blade, pull the blade-
clamp lever as far as it will go and, with
your gloved hand, pull the blade out of
the clamp.
WARNING:
For all work and
when changing the blade, always wear
protective gloves. The sharp edges of the
blade will cause personal injury. The blade
can be very hot while working.
WARNING:
Always ensure that
the tool is switched OFF and unplugged
from the power supply before making
any adjustments and attaching any
accessories.
PIVOT SHOE
SLIDING THE SHOE IN OR OUT
(FIG.3)
FIG. 3
Out In
Shoe-release lever
For maximum control and longer blade life,
the base assembly slides in or out to permit
you to adjust the effective stroke length.
1. Disconnect the saw from the power
supply.
2. Pull the shoe-release lever and slide the
pivot shoe to the desired position.
3. Release the shoe-release lever in order
to lock the shoe in the desired position.
INSTALLING SAW BLADE (FIG.2)
1. Unplug the saw from the power supply.
2. Pull the blade-clamp lever as far as it will
go to open the tool-less blade clamp.
3. Insert the blade until it stops, then
release the blade-clamp lever to lock
the blade in position.
4. Use your gloved hand to push and pull
on the blade to be sure that the blade is
clamped securely.
WARNING:
Make sure that the
front end of the blade extends through
the footplate for the entire stroke length.
Do not use specialty blades that are very
short or those with a significant cant. The
blade must not contact the footplate at
any point in its stroke. A blade that is too
short or canted could jam inside the foot
and snap.
WARNING:
For all work and
when changing the blade, always wear
protective gloves. The sharp edges of the
blade will cause personal injury. The blade
can be very hot while working.
WARNING:
Always ensure that
the tool is switched OFF and unplugged
from the power supply before making
any adjustments and attaching any
accessories.
FIG. 2
Blade-clamp lever