INSTALLING ACCESSORIES
WARNING
Do not attempt to tighten drill
bits (or any other accessory) by gripping
the front of the chuck and turning the tool
on. This may cause personal injury and/or
damage to the chuck. When removing the
bit from the tool, avoid contact with skin
and use proper protective gloves when
grasping the bit or accessory. Accesso-
ries may be hot after prolonged use.
CAUTION
Be aware that this tool is
always in an operating condition because
it does not have to be plugged into an
electrical outlet. Always lock the Trigger
Switch and remove the battery pack
before changing accessories.
1. Hold the rear end of the chuck in one
hand and use the other hand to rotate
the front end in a clockwise direction to
open the jaws of the chuck.
2. Insert the shank of the bit (or other
accessory) fully into the keyless chuck,
taking care to keep the bit in the center
of the jaws of the chuck.
3. Turn the front end of the chuck counter-
clockwise to hold the bit in place.
4. Tighten securely by turning the front end
of the chuck counterclockwise while
holding the rear end.
OPERATING THE DRILL
WARNING
Never tape the trigger switch
down to provide continuous high speed.
The tool may fail under such conditions
causing fire or personal injury.
VARIABLE SPEED TRIGGER SWITCH:
• The speed of the Cordless Drill depends
on the amount of pressure you put on the
trigger.
• The more pressure you apply, the faster
the Cordless Drill will go.
• Release the pressure and the Cordless
Drill will slow down.
FORWARD / REVERSE AND TRIGGER
LOCK LEVER:
NOTICE
Be sure the trigger is released
when changing the position of the lever.
Always store the tool in the “LOCKED/
OFF” position. Always check the direction
of the Cordless Drill’s rotation before use.
• To select forward Cordless Drill rotation,
press the trigger lock from left to right flat
against the Cordless Drill body.
• To select reverse, press the trigger lock
lever in the opposite direction.
• The center position locks the tool.
OPERATION
Trigger
Switch
Lock
Lever
WARNING
Be aware that this tool is always in an operating condition because it does
not have to be plugged into an electrical outlet. Always lock the Trigger Switch and
remove the battery pack before changing accessories.
Figure 2
Hold Here
Rotate Here
Release
Grip
