10
3
REPLACEMENT PARTS LIST
IMPORTANT SAFETY INFORMATION
OPERATION
NOTE: For best service you should incorporate an oiler, regu-
lator, and inline filter, as shown in the diagram above.
1. If desired, for quick tool connection, you will need to
prepare a 1/4” quick air connector (not included) to con-
nect to the air source hose. First, wrap the 1/4” quick air
connector (not included) with pipe thread seal tape (not
included) before threading it onto the 3/8” air source hose.
Then, connect the 1/4” quick air connector to the Air Inlet
(2) on the Grease Gun. Note: If you are not using an
7. Do not operate any tool if under the influence of alcohol or drugs. Read warning labels
on prescriptions to determine if your judgment or reflexes are impaired while taking
drugs. If there is any doubt, do not operate any tool.
8. Be sure air is in OFF position when connecting tool to air supply.
9. Use only those accessories that are designed for use with tools. For example, with
impact wrenches do not use ordinary sockets. Use impact sockets for all air tools.
10. Be sure to disconnect tool from air supply before changing accessories, performing
service on tool and when not in use.
11. Follow air source manufacturers' directions for connection of regulators, filters, and
other accessories to air source. Do not install quick couplers directly on tool as they put
unnecessary strain on the air inlet threads possibly causing them to wear out prema-
turely. Instead, install them on a short length of air hose attached to the tool.
12. Check for damaged parts. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
or mounting fixtures; and any other condition that may affect proper operation. Any part
that is damaged should be properly repaired or replaced by a qualified technician.
13. Maintenance. For your safety, maintenance should be performed regularly by a quali-
fied technician using original PERFORMANCE TOOLS® replacement parts. Failure
to do so can lead to accidents for the operator. Use of any other parts will void the
warranty. Only use accessories intended for use with this tool. Approved accessories
are available from Performance Tool®. Use only accessories that are recommended
by the manufacturer for your model. Accessories that may be suitable for one tool may
become hazardous when used on another tool.
WARNING:
This product and its packaging contain a chemical known to the State of
California to cause cancer, birth defects, or other reproductive harm.
WARNING:
The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator. Read and understand all of the instructions
provided in the instruction manual of this product, as well as, any other tool (s) used with
this product.