2
11
SPECIFICATIONS
Specifications are subject to change without notice
IMPORTANT SAFETY INFORMATION
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND
WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO
SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE AND WILL VOID WARRANTY.
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of flammable gases or liquids. Do not bring combustible
materials near the tools.
3. Keep children away. Children must never be allowed in the work area. Do not let them
handle machines, tools, hoses or extension cords.
4. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children and other untrained
persons. Switch off all unused electrical tools when stored. Tools are dangerous in the
hands of untrained users.
5. Always wear approved eye protection when using tools. If raising dust, wear a suitable
mask.
6. Work Safe. Do not wear loose clothing or jewelry that could become caught by moving
parts, causing injury. Operate tool a safe distance from yourself and others in the work
area. Keep proper footing and balance at all times. Do not reach over or across running
machines, hoses, etc.
Load: .............................Standard 14 oz. Grease Cartridge,
Pressure Filler or Bulk
Capacity.......................................................... 14 oz. (400cc)
Air Pressure (PSI): ......................................................30-150
Avg. Air Consumption (CFM): ............................................6
Air Inlet (NPT): .............................................................1/4 in.
Hose Size (ID): .............................................................3/8 in.
Length (IN) ..........................................................................16
Weight (LBS) ...................................................................2.65
Warning!
Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil
placed in the air inlet is sufficient. Use proper air pressure and CFM
rating listed for this tool.
INSUFFICIENT POWER:
Probable Cause
Solution
Dirty or clogged air passages Flush and lubricate tool, drain air tank
and supply line
Insufficient air supply
Increase line pressure, make sure
compressor matches tool's air pressure
and consumption needs
Air leakage
Use PTFE tape at all fittings and joints.
Check tool for worn or damaged O-rings
& seals.
Air pockets
Press in The Air Vent Valve (10) at the
same time pull back and fully extend the
Plunger Handle (19) several times.
Then push the Plunger Handle (19) all
the way in and tighten the Container
Tube (17) to the Gun.
Worn/damaged wear &
tear parts
Replace as necessary.
Tool matching
Be sure you are using a tool suited for
the lubing requirements of the
job at hand.
TROUBLESHOOTING