7
Attaching the Lead Wires
The lead wires provided with the TENS device insert into the jack sockets located on top of
the unit. Holding the insulated portion of the connector, push the plug end of the wire into
one of the jacks; one or two sets of the wires may be used. After connecting the wires to
the stimulator, attach each wire to an electrode.
NOTE: Use care when you plug and unplug the wires. Pulling on the lead wire instead
of its insulated connector may cause wire breakage.
CAUTION: Never insert the plug of the lead wire into an AC power supply socket.
Electrode Selection and Care
Your physician/clinician should decide which type of electrode is best for your condition.
Follow application procedure outlined in the electrode packaging which will provide
instructions for care, maintenance and proper storage of your electrodes.
Tips for Skin Care
Good skin care is important for comfortable use of your TENS device.
• Always clean the electrode site with mild soap and water solution, rinse well and blot dry
thoroughly prior to any electrode application.
• Any excess hair should be clipped, not shaved, to ensure good electrode contact with
the skin.
• You may choose to use a skin treatment or preparation that is recommended by your
physician/clinician.
• Apply, let dry, and apply electrodes as directed. This will both reduce the chance
of skin irritation and extend the life of your electrodes.
• Avoid excessive stretching of the skin when applying electrodes. This is best
accomplished by applying the electrode and smoothly pressing it in place from the
centre outward.
• When removing electrodes, always remove by pulling in the direction of hair growth.
• It may be helpful to rub skin lotion on electrode placement area when not
wearing electrodes.
