Read these safety warnings before operation.
WARNING!
Failure to read, understand and follow these warnings may result in loss of load, damage
to unit, and/or failure of unit resulting in personal injury or property damage.
WARNING!
Use this transmission adaptor only for the removal and installation of passenger car and light
duty truck transmissions. Do not overload beyond 300 lbs. Do not remove or install
transmissions with transfer cases attached.
Jack must be in fully lowered positon to move load.
Always secure transmission in place with safety chain.
Use only with heavy frame service jack with removable saddle. (See example on back page)
Read, understand and follow all warnings listed in jack instruction manual.
Vehicle must be properly supported before starting repair. Refer to vehicle owner’s manual for
proper jacking procedures.
This unit is designed for use only on hard level surfaces capable of sustaining the load. Use of
unit on other than hard level surfaces can result in instablility and possible loss of load.
IMPORTANT SAFETY INFORMATION
1. Visual inspection must be made before each use of this unit, checking for cracks, cracked welds
and missing and/or damaged parts. Any unit that appears to be damaged in any way must be
removed from service immediately.
2. BECAUSE OF THE POTENTIAL HAZARDS
ASSOCIATED WITH THE MISUSE OF EQUIPMENT
OF THIS TYPE, NO MODIFICATIONS SHALL BE
MADE TO THE PRODUCT.
3. Keep adaptor well lubricated at all points shown in
drawing at right.
4. Replace worn or damaged parts with Performance
Tool replacement parts. Be sure that only qualified
personnel perform repairs.
CARE & MAINTENANCE
1
14
14
15
15
16
18
16
14
14
20
15 16
17
10
19
2
11
11
13A
21
12
3
4
5
6
7
8
9
13B
Oil
Oil
1. Install Threaded Bushing (3), into holes in Platform (1) using Large Snap Rings (11) as shown.
2. Screw Adjustable Tilt Knob (2) through threaded bushing approximately half way.
3. Install 2 Lock Nuts (13A) approximately 3” from end of threaded shaft.
4. Install Non-Threaded Bushing (4) into holes in Pivot Frame (5) using Large Snap Rings (11)
as shown.
5. Slide Non-Threaded Bushing over onto threaded shaft and install remaining Lock Nut (13B).
6. Connect Platform (1) to Pivot Frame (5) using Pivot Pin (6), Small Snap Rings (12) and
Spacers (21) as shown.
7. Bolt on Mounting Bracket Frames (7) and Mounting Brackets (8).
ASSEMBLY INSTRUCTIONS
