8
1. Pair your device with the player.
2. Start to play music via your device (if it
supports A2DP)
3. Use supplied remote control to control play ( if
it supports AVRCP)
- To pause/resume play, press the
BF
/ .
- To skip to a track, press the
,
H
/
G
,
.
Listening to the FM Radio
Presetting Stations
Program radio stations automatically
1 Press the
FUNCTION
button to select the
TUNER source.
2 Press and hold the
M
/
Clock
button for a few
seconds to activate automatic programming.
All available stations are programmed in the
order of waveband reception strength.
- You can preset up to 20 FM stations.
- The first programed radio station is played
automatically.
Note:
- If the system is unplugged or if a power failure
occurs, the preset stations will not be erased.
• Tune to a preset radio station
- Press the
/
buttons to skip to previous/
next preset radio station.
Tuning in a Station
1 Press and hold the
/
buttons ( till the
digital display moves ), then release the
button, the frequency changes down or up
automatically until a station is found.
Troubleshooting
To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
- Ensure that the AC cord of the apparatus is
connected properly.
- Ensure that there is power at the AC outlet.
- Press standby button to turn the unit on.
Remote control does not work
- Before you press any function button, first
select the correct source.
- Reduce the distance between the remote
control and the unit.
- Insert the battery with its polarities (+/-)
aligned as indicated.
- Replace the battery.
- Aim the remote control directly at the sensor
on the front of the unit.
Poor radio reception
- Increase the distance between the unit and
your NFC compatible bluetooth device or the
TV and VCR.
Clock setting erased
- Power has been interrupted or the power cord
has been disconnected.
- Reset the clock.
No Response From the Unit
- Disconnect and reconnect the AC power plug,
then turn on the unit again.
