9
Remove the
upper drain plug
Continuous
drain hose
Press the power cord buckle
into the rear cover.
FIG. 23
FIG. 24
FIG. 25
FIG. 26
Remove the
upper drain plug
Continuous
drain hose
Threaded Adapter
(for garden hose
draining option)
WATER DRAINAGE
During dehumidifying mode, remove the upper drain plug from
the back of the unit and attach 3/4” vinyl tube included with
the unit (5/8” outer diameter). If a longer hose is needed, a vinyl
tube (3/4” inner diameter 5/8” outer diameter) can be purchased
at a local hardware store or a standard garden hose (not
included) may be attached to the threaded adapter and used for
continuous draining (for models with threaded adapters only). (A
hose length of no greater than 6 ft is recommended.) Place the
open end of the hose directly over the drain area in your floor.
See Fig. 23 & 24.
NOTE:
Make sure the hose is secure so there are no leaks.
Direct the hose toward a floor drain, making sure that there
are no kinks that will stop the water flow. Place the end of the
hose into a drain and make sure the end of the hose is directed
downward to let the water flow smoothly. (See Fig. 23.) Never
allow the hose to be directed upward at any point. (Fig. 25.)
When the water level of the bottom tray reaches a
predetermined level, the unit beeps 8 times and the digital
display area shows “P1”. At this time the air conditioning/
dehumidification process will immediately stop. However, the
fan motor will continue to operate. (This is normal.) Carefully
move the unit to a drain location, remove the bottom drain plug
and drain the water (Fig. 26). You can carefully tilt the unit back
slightly to assist with drainage. Restart the machine until the
“P1” symbol disappears. If the P1 symbol will not clear after
following the above instructions and waiting a few minutes after
restarting the machine, call Consumer Services.
NOTE: Be sure to reinstall the bottom drain plug before using
the unit.
