7
CABINET INSTALLATION
STEP 1:
TOP RAIL
1.
Remove the air conditioner and top rail (G) from the
carton and place them on a flat surface.
2.
Align the holes in the top rail with those in the top of
the unit.
3.
Secure the top rail to the unit with three of the 3/8
inch short screws (D) as shown in the diagram below.
NOTE:
Higher side of the top rail is to be facing the
inside of the room.
D–
G–
D–
D–
D. #10 x 3/8
″
pan-head Phillips
screws (3x)
G. Top Rail
STEP 2:
ATTACH SIDE ACCORDION PANELS
1.
Insert top and then bottom of right-hand accordion
panel to top rail and bottom guide on air
conditioner cabinet.
Accordion
Panel
Top Rail
2.
Extend the right-hand accordion panel outward so
you can insert the first screw through the middle hole
of the accordion panel. Using #10 x 1/4 inch pan-
head Phillips Screw (C), screw accordion panel to
middle hole in air conditioner cabinet.
NOTE:
These (6x) Phillips screws (C) are required to correctly
attach accordion panel to the air conditioner cabinet.
3.
While the right-hand
accordion is still
extended, insert
the #10 x 1/4 inch
pan-head Phillips
screws (C) into the
top and bottom slots
of accordion. Screw
accordion to the top
and bottom holes
in air conditioner
cabinet.
NOTE:
Some accordion panels may have 2 slots at each
end. You will be able to see a mounting hole through the
correct slot.
4.
Slide accordion panel housing into guides as far as it
will go.
5.
Repeat the above steps for the left-hand
accordion panel.
STEP 3:
ATTACH FOAM
ADHESIVE
SEAL
Attach foam adhesive
seal (A) along the
bottom of th accordion
panel’s bottom guide.
STEP 4:
INSTALL CABINET INTO WINDOW
• Handle air conditioner gently.
• Be sure your air conditioner cabinet does not fall out
of the opening during installation or removal.
• The location where the power cord exits the air
conditioner should be no more than 4 ft from a
grounded 3 prong outlet.
• Do not block the louvers on the front panel.
• Do not block the louvers on the outside of the air
conditioner. If air is obstructed and/or deflected back
into the unit, the air conditioner’s compressor may
cycle on and off rapidly. This could damage the unit.
INNER SILL
OUTER SILL
FOR STORM WINDOWS
WOOD FOR
INNER SILL
STORM WINDOW
FRAME
WOOD
STRIP
CAUTION:
Do not install this air conditioner in
a window if the bolts do not make contact with the window sill.
BOTTOM VIEW
BACK VIEW
Accordion
Panel
Bottom Guide
Accordion
Panel
Bottom Guide
