LEDA4011RGB/LEDA4012RGB
V. 03 – 18/09/2017
6
©Velleman nv
Mounting the Lamp
1.
This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
2.
Use the mounting bracket to determine the location of the mounting
holes.
3.
Drill the holes and secure the bracket using screws and wall plugs.
4.
Connect the power cable to a suitable junction box (not incl.). Make
sure the connection is properly earthed. Make sure there is no strain
on the cable; leave sufficient slack.
L = line, brown
E = earth, yellow/green
N = neutral, blue
Warning
: if the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order to
avoid any hazard.
5.
To point the lamp in the desired direction: loosen the hinges using a
hex key.
6.
Tilt the lamp in the desired angle and tighten the hinges.
6.
Remote Control
ON/OFF
switch on/off
/
increase/decrease brightness
FADE
7-colour gradual range
FLASH
3-colour flashing
SMOOTH
3-colour gradual change
STROBE
7-colour flashing
RGB
single colour selection
