PERCo TTR-04CW, Руководство по сборке и эксплуатации

Страница: 22 / 34

TTR-04CW Electromechanical Tripod Turnstile
Figure 12. Floor anchor position and cable entries for housing installation
10. Connect the RC panel cable (11) (WRC / ACS controller) to XT1.L connector block.
11. Connect the additional equipment if necessary (intrusion detector and a siren;
emergency unblocking device (
Fire Alarm) ; remote indicators).
12. Connect the power cable (9) from the turnstile power supply to XT3 connector block,
and also connect the cable from the power source heating system according to
Fig. 6.
13. Check serviceability and accuracy of all the electrical connections. Fasten all the
cables in two points to the hole in the turnstile housing horizontal plane, using hook
and loop cable ties.
14. Connect S1 and S2 cable connectors connecting the indication board of the cover
with the board in the housing. Mount the cover with LED indication back into its
place in the reverse order. When the cover with LED indication display mounting is
carried out correctly it does not need much effort. Fasten the cover with the bolts.
15. Install the plugs (13).
16. To mount the barrier arms into the run position, remove the cover from the hub
(3)
after unscrewing the screw. Unscrew the bolt (6), on the barrier arm (5). Fit the
barrier arm (5) into the mounting hole on the hub (3) and fasten it with the bolt (6).
Put a spring washer under the bolt head. The bolts must be tightened so as to
ensure reliable fixation of the barrier arms without a gap.
Run a test switch on of the turnstile as specified in clause 9.1 .
21