PERCo RTD-03S, Руководство по эксплуатации

Страница: 17 / 26

Operation manual
16
Table 1. List of elements of the turnstile connection layout
Legend Item Qty. Comments
A1 Turnstile post 1
A2 Control unit 1
A3 Processor module 1
A4 Remote control panel 1
A5
∗
Wireless remote control
1
A6
∗
ACS controller 1
A7
∗
External power supply 1 24VDC
A8
∗
Intrusion detector 1
A9
∗
Siren 1
A10 ∗ Railing set with indication modules
1
1 Power cable 1
2 Control cable 1
3 Indicator cable 1
* – optional
9 OPERATION INSTRUCTIONS
Warning!
It is prohibited:
− To use abrasive or chemically active substances for cleaning the external surfaces;
−
To move through the gate passage area any objects with dimensions exceeding the width
of the passageway;
− To jerk or hit the swing panel and the gate post so as to prevent their mechanical
deformation.
9.1 Power-up
Warning!
Observe general electrical safety requirements during the turnstile operation.
• Check the accuracy of all the connections and the AC power cable operability;
•
Prior to the turnstile power-up, set the «Power» toggle switch and the «Battery» toggle switch
to the “O” position;
• Install the
«Bat/2A»
fuse, which is provided together with the set of spare parts, into the fuse
slot on the CU lower panel;
• Connect the AC power cable (12) of the CU (8) to the 220V / 50Hz AC outlet;
•
Check the rotation in either direction is blocked with the mechanical release key;
•
Clear the passage area;
Warning!
Do not connect the control unit to the mains with the voltage and frequency rating other than
specified in Chapter 3 of this Manual.
• Set the «Power» toggle switch and the «Battery» toggle switch to the “I” position. At the same
time the indicators «Power» and «24V» on the CU (8) will light up, a two-tone audio signal will
be generated. The indicator above the STOP button on the RC (9) will light up.
See instructions below:
•
Any operating mode is set by pushing the buttons of the RC or the tag of the wireless remote
control kit.
•
After pushing the STOP button the turnstile is set in the “Always locked” mode, and the barrier
wings return to the reset state.