PERCo FP-01C, Инструкция по эксплуатации

Страница: 8 / 21

Certificate & Operation Manual
8
Table 1. List of components of card capture reader connection layouts
Legend Item Qty
A1 FP-01C Front panel 1
A2 Card capture reader control board 1
A3 Front end indication module 1
A4* Reader installed in a card capture reader (direction B) 1
A5* Reader (direction A) 1
A6* ACS-controller 1
A7* Power supply 24 VDC/2.5A 1
1* Power cable for the card capture reader 1
2* Cable for connecting the ACS-controller 1
3* Cable for connecting the reader installed in a card capture reader 1
* equipment is not included in the standard delivery set.
5.3 Troubleshooting
Possible faults to be corrected by the customers themselves are listed in Table 2.
For faults not listed in Table 2 we advise to consult PERCo Technical Support Department.
Table 2. Possible failures and troubleshooting
Fault Probable cause Remedy
Power supplies are on, the card
capture
reader does not
function, the slot is not backlit.
Faulty connection or breakdown
of power supply cable (9). Faulty
power supply unit. Replace the cable of the card
capture reader (9). Replace
the power supply unit.
The LED indicators are on but
the card capture reader is not
controlled by the ACS-controller. Faulty connection or breakdown
of control cable (8) of the card
capture reader (10).
Replace the control cable of
the card capture reader (10).
5.4 Card capture reader settings
5.4.1 ACS-controller configuration for working with the card capture reader in the
PERCo-Web
Attention!
•
Only controller parameter settings which are connected with card capture reader
operation are described in Appendix.
•
Visitors' cards that should be withdrawn, must be set to obligatory verification process
upon presentation to the reader in the direction controlled by the card capture reader.
1. Log into the system by using a Web browser (see PERCo-Web Administrator's manual ).
2. Go to
"
Administration
"
→
"
Configuration
"
section by using the navigation bar.
3. On the page working area select the main controller that is physically connected to the card
capture reader: