PEQUEA SuperSpread PTO 135, Руководство оператора, Страница: 14 / 28

12
Adjustments
• Metering Gate Adjustment 1). Remove pressure from stop pin by grasping adjustment disc handle (1) and
raising gate slightly. (See Image 12-1 above)
2). Slide stop pin (2) to the right removing the pin end from the adjustment disc
so that disc moves unimpaired. Turn disc to raise or lower gate. Slide stop
pin into the nearest hole on the end gate.
• Web Speed Speed increases when control is moved clockwise and decreases when it is
moved counter-clockwise. (See Image 12-2 above)
Spread Adjustments
All attachment adjustments are made by adjusting the position of the control handle located closest to the
rear of the spreader (shown above on right side).
• Brush 1). For fine, narrow row spreads the brush attachment can be adjusted by
increasing the speed of the brush by turning the controls to the right or
decreasing the speed of the brush by turning the control adjustment to the left.
2). Further adjustment can be obtained by moving the brush vertical or horizontal
to compensate for brush wear. Bristles should only lightly brush against the
belt. Excessive contact will unnecessarily wear bristles and damage the belt.
• Delivery Beater 1). Adjusting beater speed causes spread width to increase or decrease.
2). Row width increases when control is moved clockwise and decreases when it
is moved counter-clockwise.
3). Row width will vary from 5'-12'.
4). Additional adjustment can be made by moving the beater up or down as it is
mounted to the spreader. NOTE: Vertical adjustments up or down require
realigning the beater in relation to the belt. Loosen bolts that secure the
beater drive motor and move it in or out accordingly. The best position for
the beater is
5 /
16
" from the belt, but never less than
1
/
4
".
Attachment Adjustments
Image 12-2 Image 12-1
1
2