Peqlab peqSTAR 2X, Инструкция по эксплуатации

Страница: 26 / 48

Instruction Manual peqSTAR X thermal cyclers
PEQLAB_v1212E
21
Cycle
9.3.7 Cycle:
Use this button to define a program cycle
(loop), consisting of several individual
program steps.
In the field 'Number of Cycles' the amount
of cycles is entered.
In the following dialogue the commands
'Temp' and 'Gradient' can be entered in
the cycle. The corresponding values are
explained in chapter 9.3.4 and 9.3.6.
When all steps of the cycle are
programmed, the dialogue could be left
using the button 'Close Cycle'.
Start Cycle
9.3.8 Start Cycle - Manual cycle beginning
Close Cycle
9.3.9 Close Cycle - Manual cycle ending
Pause
9.3.10 Pause
Use this button to interrupt the running
program temporarily.
The adjoining window appears where you
can enter a temperature value for the
pause
Store
9.3.11 Store
This command keeps the thermal plate
temperature on the set value.
Automatically the lid heat is turned off.
This command usually is the last program
step, and is used to store the samples at a
constant temperature until removal.
If the exact time of sample removal is
uncertain activate the 'Infinite' field to store
for an infinite time.