Ultrasonic Double Sheet Monitor UDC-18GMA-400-3E2
Commissioning and parameter assignment
D
at
e of
ed
iti
on:
12
/1
7/
04
10
Subject to reasonable modifications due to technical advances.
Copyright Fuchs, Printed in Germany
Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com
6.5.1
Programs
*) The measurements were made under the following conditions: d = 45 mm, a = 10 mm,
β
= 0°
**) The measurements were made under the following conditions: d = 45 mm, a = 10 mm,
β
= 35°
6.5.2
Procedure for assigning parameters
It is possible to switch to additional parameter assignment modes from the
display mode:
Alignment aid mode -->
Program selection mode -->
Alignment aid mode -->
When the function input (PK) is applied to -U
B
(for > 500 ms), the mode chan-
ges. When the "Program selection“ mode is active, switching on function input
(PK) on to +U
B
(for > 500 ms) selects the next program level.
Disconnecting the power supply causes the system to exit the current mode
with the selected program change.
The switch outputs are not active while parameters are being assigned to the
sensor!
Program
number
Notes
*
Range of materials
Dimension b
(fig. 5.1)
1
Default setting, standard paper
20 - 1200 g/m
2
> 15 mm
2
Thick paper, cardboard, fine corrugated boards
(DIN 55 468
-
1)and thin sheet metal**
> 100 g/m
2
> 20 mm
3
Thin paper
20 – 250 g/m
2
> 11 mm
4
Extremely fine paper
< 40 g/m
2
> 8 mm
