1. Insert the positive and negative wires into the V+ and V- contact
on the terminal block connector.
2. Tighten the wire-clamp screws to prevent the power wires
loosened.
Wiring the Relay Output (DO)
The relay output contacts are in the middle of the terminal block
connector as shown below. Insert the wires as show below to connect
the relay output alarm so that it detects power fault and avoids
forming a short-circuit.
Note:
The relay contact only support 1A current, 24VDC.
Fuchs does not recommend apply higher voltage and current
that over this specification.
3
Electronic.indd 3
12/4/2019 9:16:57 AM
