Pepperl+Fuchs PGV Series, Руководство пользователя, Страница: 44 / 48

2
0
1
7
-1
1
44
PGV...-F200/-F200A...-B17-V1D
Operation and communication
Global Primary Data
The global primary data allows you to parameterize the reader using PROFINET. Global
primary data is always transferred to the reader in full.
Sub-
index Designation
Function
Parameter
data
Data type Primary data
0 Number of
Subsequent
Parameters unsigned8 11
1 X resolution Multiplier for the
length in the
direction of the X
coordinate Resolutio
n unsigned32 0.1 mm
1 mm
1
10 mm
1. Bold = default values
2 Y resolution Multiplier for the
length in the
direction of the Y
coordinate Resolutio
n unsigned32 0.1 mm
1 mm
10 mm
3 Angle
resolution Multiplier for the
angle output Resolutio
n signed32 -16,384 – 16,384
360 -> 1
°
4 Horizontal
offset Offset in the
direction of the X
coordinate Length signed32 0 mm
– ±
10,000,000 mm
5 Vertical offset Offset in the
direction of the Y
coordinate
Length signed16
0
– ± 16,383 mm
6 Angle offset Line of vision
offset Angle signed32 -16,383
–
0
–
16,383
7 No position
value X X value if no code
tape is visible X data at
"No
Position" Array of
unsigned8
Octet 0-3 Last Valid Position (0x00)
Specified Value (0x01)
No Position
Specific X
Position Specific X value Octet 4-7
0
– 100,000,000
8 No position
value Y Y value if no code
tape is visible Y data at
"No
Position" Array of
unsigned8
Octet 0-3 Last Valid Position (0x00)
Specified Value (0x01)
No Position
Specific Y
Position Specific Y value Octet 4-7 0
–
16,383
9 No position
value angle Angle output if no
colored tape is
visible Angle
data at
"No
Position" Array of
unsigned8
Octet 0-3 Last Valid Position (0x00)
Specified Value (0x01)
No Position
Specific
Angle
Position Fixed angle Octet 4-7 0 –
65,535
10 Bandwidth Width of the
colored tape Width unsigned32 10 mm – 40 mm
18 mm
11 Color Color of the tape Color unsigned32 1 = blue (RAL 5015)
2 = green
(RAL 6032)
4 = red (RAL 3001)
8 = yellow (RAL 1021)
12 Input Source
Selection
2
2.If you would like to control the inputs via the protocol, you must set this parameter to 1 = Software.
Selecting the
source of the input
data Selection unsigned32
0 = hardware input
1 = Software