Hostname
(Optional)
Provide a hostname for this WAN port if requested by the ISP
Management IP
Address
Management IP Address
is available for configuration when you click the link in the help
icon via the Hostname.
This option allows you to configure the management IP address for the DHCP WAN connection.
DNS Servers
Select a DNS server for this port to use. This port can either be automatically selected or manually
designated.
Ip Passthrough
When this IP Passthrough option is active, after the ethernet WAN connection is up, the router's
DHCP server will offer the connection's IP address to one LAN client. All incoming or outgoing
traffic will be routed without NAT.
Independent from
Backup WANs
If this is checked, the connection will be working independent from other Backup WAN
connections. Those in Backup Priority will ignore the status of this WAN connection, and will be
used when none of the other higher priority connections are available
Standby State
This option allows you to choose whether to remain the connection connected or disconnect it
when this WAN connection is no longer in the highest priority and has entered the standby state.
Reply to ICMP
Ping
If No is selected, this option is disabled and the system will not reply to any ICMP ping echo
requests to the WAN IP addresses of this WAN connection(Default option is “Yes”)
Upload Bandwidth
This field refers to the maximum upload speed.
This value is referenced when default weight is chosen for outbound traffic and traffic
prioritization. A correct value can result in effective traffic prioritization and efficient use of
upstream bandwidth.
Download
Bandwidth
This field refers to the maximum download speed.
Default weight control for outbound traffic will be adjusted according to this value.
WAN > Physical Interface Settings
Physical Interface Settings
Port Speed
This setting specifies port speed and duplex configurations of the WAN port. By default,
Auto
is
selected and the appropriate data speed is automatically detected by the Pepwave router. In the
event of negotiation issues, the port speed can be manually specified. You can also choose
whether or not to advertise the speed to the peer by selecting the
Advertise Speed
checkbox.
MTU
This setting specifies the maximum transmission unit. By default, MTU is set to
Custom 1440
. You
may adjust the MTU value by editing the text field. Click
Default
to restore the default MTU value.
Select
Auto
and the appropriate MTU value will be automatically detected. Auto-detection will run
each time the WAN connection establishes.
MSS
This setting should be configured based on the maximum payload size that the local system can
handle. The MSS (maximum segment size) is computed from the MTU minus 40 bytes for TCP
over IPv4. If the MTU is set to
Auto
, the MSS will also be set automatically. By default, MSS is
https://www.peplink.com
45
Copyright @ 2021 Peplink
Содержание Pepwave Surf SOHO
