PEP Modular Computers CP341, Руководство пользователя

Страница: 31 / 34

CP341 Installation
ID 18845, Rev. 0102 Page 3 - 5 ® PEP Modular Computers GmbH
However, if your system runs into an error during network connection, its configuration
may require additional steps. In this case, please refer to the
readme.lst
file on the
Driver disk.
3.1.5 AC Power Connection
3.2 Software Installation
The CP340 is fully compatible with the plug & play philosophy. As it uses standard Win-
dows NT drivers it does not need any jumper setting and, therefore, does not require
any hardware configuration. A complete set of drivers is located on the
PEP Modular
Computers Drivers disk supplied with the CP340.
3.2.1 Automatic Configuration
CompactPCI systems automatically detect and configure PCI-compliant interface
boards while booting. The CP341 IRQ level and I/O address are automatically set by
BIOS each time you start your system.
Thus, for configuring your computer after having mounted the CP341 board, just boot it.
Configuration is complete when Windows NT starts or the DOS prompt appears.
3.2.2 Installation of Network Drivers
After having inserted your CP341 board into the CompactPCI backplane and started
Windows NT, you need to install the Intel board drivers and test your CP341 board. Pro-
ceed as follows:
• Double-click the “Network” icon in the “Control panel”.
• Click “Adapters” tab.
!
Attention!
Before reconnecting the computer your CP341 was fitted into to AC
power, replace the dummy front panels of your tower. Failure to do
so could endanger your life and may damage the board and/or
computer.
$ $
Important!
Connect the computer your CP341 is fitted into to AC power only
after having mounted it in a suitable location and correctly com-
pleted all network connections.
$ $
Important!
To ensure full functionality please use the Intel 82558 Ethernet
driver disk supplied with your adapter board.