Operator’s manual Pentruder RS2 wall saw and Pentpak 3 HFi power pack – Original instructions
Page 41
6.1.8
Arm transmission
Check the condition of the gearbox oil (arm transmission) every week. To check, clean thoroughly around the plug
and blow with compressed air before the plug is removed. If dirt is allowed to enter, the gearbox may seize and the
warranty is not valid.
If the oil seems to contain water, it needs to be replaced. Please contact your Pentruder authorized workshop for
service.
6.1.9
Water filter on Pentpak 3
The Pentpak 3 is equipped with a built in water filter. Depending on the water quality the water filter should be
checked every week. Also check it if the water flow is lower than normal.
a.
Take apart the filter, using a 19 mm wrench.
b.
Check the condition of the filter and replace if damaged.
c.
Clean the filter if it is in ok condition and reassemble.
How to clean the water filter on Pentpak 3
6.1.10
Transport trolley
The maintenance instructions for the other parts of the wall saw also apply when they are to be mounted on the
trolley. Always check the overall condition of the trolley and tire pressure before use and clean when needed with
water and brush to make sure all parts can be mounted safely without damaging the equipment. Tighten screws and
nuts on the trolley if necessary. Please contact your Pentruder authorized workshop for help and spare parts.
!
Important!
•
You may not replace the lifting eyelets on your own initiative, and they must
always be positioned correctly (see 3.2.1)
•
Do not use the trolley if any of its load-bearing parts have been damaged/
deformed or show signs of corrosion, this especially applies to the lifting eyelets
if they are to be used.
•
The trolley must not be used if the pre-mounted plastic plugs on its sides are
damaged or missing.
•
Do not use a high-pressure washer to clean the trolley.
