Operator’s manual Pentruder RS2 wall saw and Pentpak 3 HFi power pack – Original instructions
Page 16
WARNING!
MOUNT ACCORDING TO INSTRUCTIONS
Risk of serious or fatal cut from saw blade. Uncontrolled movements of the saw or
an escaping or falling saw blade may result in injury or death. Risk of injury from
falling parts.
Uncontrolled movements of the saw or an escaping or falling saw blade may result
in injury or death. Risk of injury from falling parts.
•
Track feet may only be mounted according to instructions given in this manual.
•
Ensure that the surface where the track feet are fastened is stable, free of
obstacles and adequately lit.
•
The track feet and the tracks should be mounted in such a way that they
cannot become detached when the machine is working, or at sudden changes
in load on the anchor bolts.
•
Track stops must always be securely mounted at each end of the track(s) to
prevent the saw head from being run off the track unintentionally.
•
If HKD type anchors or other high-quality expansion anchors cannot be fixed
securely, the track feet must be securely fixed with through bolts and large
washers to achieve the required level of safety.
•
Do not use the machine if the track feet cannot be fastened properly.
•
Make sure that the fork is not threaded all the way out before the track is
mounted. Leave at least one turn from the fully out or in position of the fork.
3.3.2
Track system parts
a.
Track stop
b.
Knurled knob
c.
T-slot piece
d.
Fork
e.
Sleeve nut
f.
Levelling screws x 3
Note!
The
track feet
should preferably be mounted in the position shown in the picture
above, with the base plate of the track foot under the track. If the track feet must
be mounted differently due to the circumstances, this will affect the stability of the
track and more track feet should be fitted to spread the load for increased stability.
