Operators manual for the Pentruder 6-12HF and Pentpak HF-power pack – Original instructions
Page
23
Peripheral cutting speed and spindle speed in metres / second for different blade diameters,
@ 400Hz: (Set potentiometer at 90% on the remote control)
Gear
Ø 600
Ø 700
Ø 800
Ø 900
Ø 1000
Ø 1200
1 = 720 rpm
22.7 26.5 30.2 34.0 37.8
45.4
2 = 1075 rpm
33.8 39.4 45.1 50.7
Not
permitted
Not
permitted
Pentruder 6-12HF with 15 / 18 kW HF-motor and potentiometer setting at 90%.
Peripheral cutting speed and spindle speed in metres / second for different blade diameters,
@ 440Hz: (Set potentiometer at 100% on the remote control)
Gear
Ø 600
Ø 700
Ø 800
Ø 900
Ø 1000
Ø 1200
1 = 800 rpm
25,2 29,4 33,6 37,8 42,0
50,4
2 = 1200 rpm
37,6 43,8 50,1
Not
permitted
Not
permitted
Not
permitted
Pentruder 6-12HF with 15 / 18 kW HF-motor and potentiometer setting at 90%.
Warning! The gear selection knob may not be operated before first disconnecting the two
power cords from the saw. This important rule must always be strictly followed to ensure
that the blade motor cannot be started unintentionally. Failure to follow this instruction may
result in serious personal injury or death.
The power pack can be placed out of sight of the operator, out of reach for the operator, or
on a different level, and the only way to protect the operator from accidental starting of the
blade motor is for the operator to always disconnect the two power cords. With the power
cords disconnected no power can go to the saw head.
Warning!
The peripheral cutting speed may not exceed approximately 56 metres / second
as this can cause the blade to fail. In the worst case segments can come loose and be
thrown with high velocity.
Warning! If the wrong gear and potentiometer setting is used the blade can rotate with a too
high peripheral speed, which can cause the blade to fail and lead to fatal injury.
