23102
Page 13
f. ASSEMBLY AND ADJUSTMENT OF SELECTOR GEAR MECHANISM
(1)
Assembly of high Speed Lever Parts
After cocking the shutter, fix the bulb lever (05007) to the bulb lever shaft (05050). If the tip of the
bulb lever (05007) hits the selector gear bottom retainer plate (05012), grind the tip of (05007) with a
grindstone.
Assemble the high speed lever (0-05005) with the bulb lever (05007), and insert them again into
(05050). Hook the high speed lever spring (05120) on the indicator seat (05104) and screw the bulb
lever nut (05103) onto (05050). Check with the tip of tweezers if both parts (0-05005 & 05007) move
smoothly.
(2)
Assembly and Adjustment of Shutter Rod
Assemble the shutter rod spring (05117-1) and the shutter rod (05051) which is calked to the release
plate (05004). Insert the shutter rod (05051) into the hole of (03001) through the top of (01001) and
also into the lower hole of (01001). At the same time, arrange the intermediate gear retainer screw
(05092) to get into the hole of (05004).
Fix an (LW 10) washer to the lower part of (05051) through the bottom part of (01001). From the front
of (05051), .fasten the shutter actuator plate (05022) with two shutter actuator plate retainer serews
(05088).
Adjustment of (05022) should be made after the mirror housing has been assembled into the body
proper (01001). The difference in height between the selector gear retainer plate B (05013) and the
bulb lever (05007) must not exceed 1/3 of the thickness of the plate (05013).
When the 1st curtain checker arm (05008) is released after cocking the shutter, (05013) slightly rotates
and stops by colliding against the bulb lever (05007). If the bulb lever (05007) is slowly turned
counter-clockwise with the tip of tweezers, it should be removed smoothly from (05013).
Note: Remember to prevent the lubricant on the high speed lever (05005) from spreading over the gear parts.
(3)
Assembly and Adjustment of Bounce Stopper Mechanism
First, temporarily fasten the bounce stopper adjust screw (05109) to the back of the body proper.
Ratain the bounce stopper lever (05010) together with (W 31) with the bounce stopper screw (05101).
The tip of the arm (05010) should not have such up-and-down clearance as to get loose from the head
of (05109). If necessary, adjust the clearance with (W 27) washers.
