Pentair STA-RITE PLM100, Руководство пользователя

Страница: 10 / 12

10
1. Short Cycle Time:
NOTICE: CycleTime will vary with each installation
and between different areas of the country. The
following causes and remedies are for cycle times
shorter than normal for your area.
A. Chlorine residual too low; maintain proper residual
(consult pool professional for recommendation).
B. Flow rate too high; restrict flow to rated capacity
of filter (see instruction plate on filter or
specifications on Page 4).
C. Filter is too small; install an additional filter.
D. Filter module is dirty or plugged; thoroughly
clean the filter (see No. 4, “Plugged Module
Cloth”, and “Module Cleaning Procedure",
Pages 7 and 8).
E. Water is chemically out of balance; consult pool
professional.
F. Algae in the pool. Apply heavy dose of chlorine
or algicide as recommended by the pool
manufacturer.
2. Low Flow/High Pressure:
A. Elements plugged; clean filter thoroughly (see
Pages 7 and 8).
B. Pipe blocked downstream from filter; remove
obstruction.
C. Piping too small; use larger pipe (consult dealer
for sizing).
D. Filter area too small; install an auxiliary filter
(consult dealer for recommendation).
E. Outlet port check valve obstructed (if applicable);
remove obstruction to allow valve to open.
3. Low Flow/Low Pressure:
A. Pump too small; consult dealer for
recommendations.
B. Plugged pump or plugged hair and lint trap;
clean thoroughly.
4. Plugged Module Cloth:
A. Insufficient cleaning; follow cleaning instructions
closely and clean thoroughly (see Pages 7 and
8).
B. Water is chemically out of balance; consult pool
professional.
C. Excessive air in filter. Vent air from tank and
check for pump suction pipe leaks. Clean air
bleed filter in module assembly with a hose and
soft flow nozzle.
D. Filter is too small. Install an additional filter.
E. Pool water contains iron. See “Special Cleaning
Instructions”, Page 8.
F. Heavy or improper application of powdered
chlorine tablets using a binder. See “Special
Cleaning Instructions”, Page 8.
G. Algae in the pool. Apply heavy dose of chlorine
or algicide as recommended by the pool
manufacturer.
H. Use of incorrect chemicals with PHMB sanitizers.
Replace filter module.
5. Pool Water Not Clean:
A. Chlorine residual too low; maintain adequate
chlorine residual (consult pool service technician
for recommendation).
B. Filter module cloth torn, plugged, or punctured;
replace module.
C. Inadequate turnover rate; consult dealer to verify
that equipment is properly sized for your pool.
D. Pump is too large and is overpumping. Reduce
the flow rate.
E. The filter is installed backwards. Reinstall it
correctly.
F. Pool water contains iron. See “Special Cleaning
Instructions”, Page 8.
G. Heavy or improper application of powdered
chlorine tablets using a binder. See “Special
Cleaning Instructions”, Page 8.
H. Algae in the pool. Apply heavy dose of chlorine
or algicide as recommended by the pool
manufacturer.
6. Pool Accessories Stop Working:
A. Clean filter and observe performance of
accessories.
B. If accessories perform better after filter has been
cleaned, use a shorter cleaning cycle for the filter
(that is, clean the filter after a pressure rise of
less than 10 PSI).
TROUBLESHOOTING GUIDE