Pentair Sta-Rite EcoSelect Enviromax 800, Руководство пользователя

Страница: 13 / 20

The EnviroMAX 800
should only be serviced by certified Pentair service agents.
For best results and to ensure warranty is not void, insist on use of only genuine Pentair
service parts.
To avoid dangerous or fatal electrical shock hazard, turn OFF power to pump and remove
plug from power outlet before working on pump.
The power supply cord has a type 'Y' attachment and if service is required to the power
cord, it must be replaced with the specialised power cord assembly by Pentair Water
service agent or similarly qualified personnel in order to avoid a hazard. Warranty is void
if unauthorised modifications are made to any component.
Troubleshooting guide
SYMPTOM CAUSE REMEDY
Low water pressure, low
flow from pump.
Suction leaks / lost prime. ► Pump must be primed; make
sure that the pump casing and
strainer are full of water. Refer
priming instructions.
► Make sure there are no leaks
in suction piping and ensure all
o-rings are present and clean.
► Make sure suctions pipe inlet
is well below the water level to
prevent pump from sucking air.
► Suction lift of 3 to 6 metres will
reduce performance. Suction
lift of more than 6 metres will
prevent pumping and cause pump
to lose prime. In either instance,
move the pump closer (vertically)
to water source. Ensure that the
suction pipe diameter is large
enough.
Low speed setting. ► Check speed setting. Refer
to speed selection section of
this manual. Reset to default if
necessary.
Clogged pipe / strainer /
impeller / filter system.
► Ensure trap is not clogged with
debris; clean basket and/or filter.
► Make sure that the impeller is not
clogged. This should be checked
by qualified personnel only.
► Pump may be trying to push
too high a column of water. If
so, a higher pressure pump is
required.
Troubleshooting
12