SLIMLITE Pool Light Installation and User’s Guide
8
9. Place the two new thermal strips (provided) over the circuit board studs in
the base of the light housing.
10. Place the light circuit board over the base studs and seat the circuit board
on top of the thermal strips. Be sure the two connecting wires are not caught
between the housing and the edge of the circuit board.
11. Using a ¼” nut driver, tighten each of the four (4) retaining nuts to a torque value
of 6.0 (minimum) to 8.0 (maximum) in-lbs to secure the circuit board. DO NOT
OVERTIGHTEN THE CIRCUIT BOARD NUTS.
12. Connect the two connector plugs to the circuit board terminals.
13. Install the SlimLite Light Assembly with new Lens and Gasket: See
page 9-13.
A NEW LENS GASKET (P/N 620400Z) MUST BE USED EACH
TIME THE SLIMLITE LIGHT IS REASSEMBLED.
Installing the SlimLite Light Circuit Board (See Figure 8)
Note: Note the current position of the lens at the pilot screw (12 o’clock)
position, before removing it from the fixture. “W” on the lens indicates wide
angle, “N” indicates narrow angle. For more information, see page 8 and 9.
CIRCUIT BOARD - REMOVAL / INSTALLATION
