13
Operation
Commissioning
Put a small amount of water in the tank (just above the level of the tank sensor).
Open a tap on the outlet side of the WaterSwitch (or have someone flush the toilet).
The pump will start. Turn off the tap, and the pump will stop.
Temporarily disconnect the level sensor connection (fitting in base). This indicates to
the WaterSwitch that there is no water in the tank, and that it will switch
to mains supply operation.
Again, open the tap or flush the toilet. Main supply water will fill the cistern. Close
the tap, and replace the level sensor connection. If there are any variations to these
outcomes, please see the troubleshooting section on page 16.
Status
Manual
Override
