Pentair JUNG PUMPEN HIGHLOGO 1-910, Инструкция по эксплуатации и ремонту

Страница: 31 / 36

1900 Series Horizontal Splitcase Pumps
Instruction and Repair Manual 31
11/12/18
STARTING PUMP AFTER REASSEMBLY:
Do not start pump until all air and vapor have been bled. Make sure that there is liquid in the pump to provide
necessary lubrication.
NOTE:
Do not overtighten standard packing assembly before returning unit to operation.
CAUTION:
Read operating instructions carefully before starting pump.
Jog pump to check for proper rotation. Allow it to run a short
time. Gradually tighten nuts (19A) until dripping has been
reduced to its normal level.
Overtightening the packing will cause stuffing box to overheat.
The shaft sleeve will also receive excessive wear.
K. Inboard impeller removed. Shaft sleeve in place.
NOTE: WHEN ORDERING SPARE PARTS ALWAYS INCLUDE THE PUMP TYPE, SIZE, SERIAL NUMBER, AND THE PIECE NUMBER FROM THE EXPLODED
VIEW IN THIS MANUAL. ORDER ALL PARTS FROM YOUR LOCAL AUTHORIZED DISTRIBUTOR, OR THE FACTORY AT NORTH AURORA, ILLINOIS.
PREDICTED LIFE:
Reference
Number Description
Predicted
Life
1 Impeller 10 years
2 Casing, Lower 20 years
3 Casing, Upper 20 years
14 Shaft Sleeve 5 years
16 Wear Ring, Casing 5 years
17 Wear Ring, Impeller 5 years
163 Bearing, Radial 100,000 hours
168 Bearing, Thrust 100,000 hours
212 Packing 1 year
456 Mechanical Seal 5 years
Table 2
RECOMMENDED SPARES:
Reference
Number Description
Associated Kits
Seal
Kit
Overhaul
Seal Kit
Rotating
Kit*
Rotating
with
Impeller
Rings*
*A1 Impeller, 1st Stage x x
*B1 Impeller, 2nd Stage x x
*4 Pump Shaft x x
10 Water Seal Ring, Set x x x x
14 Shaft Sleeve, Set x x x
16 Wear Ring, Casing, Set x x
17 Wear Ring, Impeller, Set x
126 Deflector, Set x x x x
163 Bearing, Radial x x x x
168 Bearing, Thrust x x x x
212 Packing Set x x x x
456 Mechanical Seal, Set x x x x
Gaskets, Set x x x x
Table 1
*Recommended for severe duty applications.