Pentair Intellitouch ScreenLogic, Руководство пользователя

Страница: 87 / 116

77
IntelliTouch ScreenLogic User’s Guide
System Error Messages
If a system error has occurred with IntelliTouch equipment, the displayed error message is displayed in yellow.
System Delay Cancel Feature
For convenience, on a one time basis, the Cancel Delays feature will cancel the following safety delays which can be
set up in the IntelliTouch system. Please note there is generally not a need to cancel any of these delays except for
servicing or testing the system.
When the following pumps are switch on, if Pool Off Delay is selected and the Cancel Delay button is pressed, the
following describes how each pump is affected:
• Heater Cool-Down Delay Cancel: Shuts Filter Pump off immediately.
• Two-Speed Filter Pump 5 minute START on HIGH SPEED Delay Cancel: Shifts pump to low speed.
• Automatic Pool Cleaner START Delay: Starts Cleaner Pump immediately. Normally there is a delay in
which the filter pump first runs for 5 minutes before the cleaner pump starts.
• Automatic Pool Cleaner-SOLAR Delay: Allows Cleaner Pump to run even though solar delay has shut it
off for 5 minutes.
About the Heater Cool-down Cycle and Delay Cancel
Some heaters require a cool-down cycle before being turned off. This can be accomplished with a setup procedure
in the IntelliTouch system which runs the filter pump an additional ten minutes to dissipate residual heat built up inside
the heater combustion chamber. The delay feature is mainly for use by service technicians when they want to shut
the filter pump off immediately, and know the heater has not been running.
IMPORTANT: Heaters manufactured by Pentair Water Pool and Spa do not require this cool-down period and
do not need the delay to be set up.
To cancel a safety delay:
1. From the ScreenLogic main screen, tap the Equipment tab.
2. Tap the delay to cancel from the System Delays box, and tap the Cancel Delays button.
The delay options are:
• Cleaner On Delay
• Pool Off Delay
• Spa Off Delay
Enable/Disable Spa-Side Remotes
To disable or enable the spa-side remotes from ScreenLogic:
1. From the main ScreenLogic screen, tap the Equipment tab.
2. Tap the Enable or Disable button to enable or disable the iS10 or iS4 spa-side remote.